Posts by luntho

same here..ordered within an hour after announcement and still nothing

the manual is available at the kemper website, download section

didn't know about this for android..just tried it and it works...nice:)

yep, same here, no pay button

if you use the fullrange mode the monitor cab should be on...use the imprints with monitor cab off

seems to work on some profiles but not on others..

did you get this sorted out?

set the mix on the fx to 0 (=off) and use morphing to turn it on by increasing the mix to 100 or whatever you want.

dropbox free 2Gb

https://www.dropbox.com/en_GB/basic

interesting...have you tried to make a kemper profile of the tonex?

thanx

I have a Gibson p94 in my epi sheraton (semihollow) and it sounds great. haven't tried it in a les paul though.

this one is funny...

GHS Boomers 9-46 or 10-46...sometimes ernie ball same gauge....have used elixir coated a few times but they cost like 3 sets of boomers

found this clip on YT,

I have the same problem...I got the id14 a few weeks ago and did a short attempt reamping but as I remember my problem was that I couldn't get the di signal out through output3 only...it was always present in all outputs... I will try to find the time to get it working...after all the 4 outs was the reason I sold my old id 14 and got the new version2 for reamping.....I'll follow this thread with great interest...hope you get it sorted out.

I have the qsc k10 as well as the yamaha dxr10 and headrush 12...the headrush was my favourite until I got the kemper kab. didn't like the qsc at all but when used with the helix stomp it sounds great..much better than all the others... but for the kemper I would go for the kemper kab no doubt.

it's possible on the toaster so it must be on the rack too

thank you

Thank you!