Posts by herecomesevan

    I'm trying to profile my Mig-50, and the Kemper just isn't matching the sound at all.

    I did a "clean" profile and had no problems, except for the "Noise Gate Detected" (everybody I talk to apparently gets this error and they just ignore it.)

    But when I set the amp a little hotter, on the breakup edge, the kemper can only profile it super clean or way too distorted and mushy. When I set the output to "Clean" on the Profiling Assistant, the profile I get back is way cleaner than the reference amp. I have the opposite problem when I set it to "Distorted," Where the profile comes out gross, mushy, and not like the reference amp at all.

    Signal chain is Kemper - Amp - Loadbox - Kemper. No pedals, interfaces, DAWs etc. in between

    What am I missing?