Posts by thisamplifierisloud
-
-
Das Manual weiß darüber auch Bescheid.
-
In addition use the output lowcut. Set to 80...130Hz.
it might sound thin playing alone, but you'll better cut the mix.
-
Still missing my old replifex... but at that point only.
-
none
But in stereo !
-
- A Kemper "Light" without profiling capability.
- Pre and Post Amp Studio EQ
- more Rotary Parameters, especially Acceleration
- Expression Pedals free assignable to any Parameter
- LFO free assignable to any Parameter
And Hardware ... Ethernet and USB connectors built like tank
-
Wood was not good enough - one my favourite rigs disappeared yesterday.
-
Oh, yeah, Burkhard... thank you !
I´m not using a Volume Pedal, but it was locked.
The problem was sitting in front of the toaster.
-
Actually using 8.7.9, but I noticded this a few versions before , too.
Way to reproduce at my toaster (RigManager not connected) :
Browser mode, switch between rigs using Rig left/right buttons.
STORE is always on.
After selecting an effect, the STORE button´s LED turns off. EXIT : STORE is lit.
Pressing STORE, then replace : STORE LED off.
Then switch to next rig and back, STORE LED is on again.
Bug, feature or am I doing something wrong ?
Best regards
Bernhard
-
Didn´t have any problems since updating toaster to 8.7.8
Using for hours without thinking about anything.
Kock on wood !
-
Was wondering, too.
But I don't need the EQ button.
Idea : Turn on/off/select a post amp studio EQ, so there's no need to waste a stereo slot for it.
-
- Without using a slot and per rig : Studio EQ at input, pre and post Amp.
- Also a Studio EQ for each output.
- acceleration parameter for Rotary
- 2 or 3 more slots pre and post amp
- LFO for each (or many) parameters
-
Same here, already complained in another thread.
Sometimes it happens, maybe I am not careful enough.
To avoid loosing rigs I copy all relevant rigs to my computer before playing around.
-
-
Meiner fängt auch an zu zicken.
Gestern in der Probe wollte nur das Gain korrigieren- es war schlicht nicht möglich.
-
Very strange ... I figured out :
For saving I use always the Store-Button of the real Kemper.
In addtion I ensure that in RigManager the focussed and selected rig is unchanged.
And after storing I wait at least 10 seconds before touching anything except a cup of coffee.
-
Happened again.
Rig Manager open, some fonding around with Green Scream in Slot B, Store - Replace.
Switch to next rig at Kemper, suddenly the treated rig was doubled and the rig I switched to is gone.
Correction : Not doubled rig.
The rig to be replaced was NOT replaced. Instead of the next rig in the list was overwritten.
-
Occasionally I have the same strange behaviour.
But I cannot reproduce it.
Sometimes restarting the RM helps.
Maybe RM and Toaster are loosing snchronity ?
-
-
Or a new Kemper with 10 slots pre and 10 slots post amp- section.
