No sound outta of speaker output

1st Official Post
    • New

    I have a kemper power rack , had a show the other work perfectly as always . Went to use it today and have no sound out of my speaker cab. I’ve check setting , made sure power is turned on . You can hear the relay click . Tried different cables and another cab just in case and nothing . Headphones work and monitor outs work . No speaker out .

    Need to resolved this fast .

    • New

    This same thing happened to me once before. I did a "init globals" on the system settings to get back to default settings, and then turned the Power Amp on and everything was working again. I never found out what I did to cause the power amp not to make sound.

    Larry Mar @ Lonegun Studios. Neither one famous yet.

    • New
    • Official Post
    Quote from BayouTexan

    This same thing happened to me once before. I did a "init globals" on the system settings to get back to default settings, and then turned the Power Amp on and everything was working again. I never found out what I did to cause the power amp not to make sound.

    the SPEAKER OUT gets the same signal as the Monitor Output, so if Monitor Output is set to 'Off' there will be no signal.

    also on page 10/10 ('Power Amp') of the OUTPUT Section there is a Volume control, if set to -inf there will be no signal.
    these parameters would also have been initialized back to 'normal' settings when doing the 'init global' procedure